Cel-Fi Go X Repeater RFI CD7197 Trucker Edge Kit 3G/4G is suitable for trucks, 4WD, RV, Motor Home and other vehicle applications. Supports either Optus or Vodafone and can boost two frequencies allowing simultaneous 3G and 4G operation. Includes a CD7197-B 7.5dBi RFI Stainless Spring Black Fibreglass Omni Antenna and Coverage Antenna. For low loss extension cables and antenna mounting brackets, see ACCESSORIES below.
Cel-Fi Go X Smart Repeater Mobile model is based on the Nextivity's Cel-Fi GO Mobile Phone Repeater and has been tested, authorised and approved by Optus and Vodafone for use on their networks.
Cel-Fi Go X will boost 3G and 4G on either the Optus or Vodafone (selectable) Australian cellular network and is is designed to dramatically boost voice quality and increase data speeds for in vehicle, 4WD and building applications. Note that the Cel-Fi Go X when configured for Vodafone will not boost the Vodafone Regional network. You can tell you’re using the Regional Network when ‘Vodafone AU R’ or ‘Voda R’ appears on your phone. This is due to the Regional Network roaming on a partners network. More information can be found on Vodafone’s Regional Network page.
When configured for Optus, the Cel-Fi Go X operates on 3G 900Mhz or 4G 1800/2600MHz bands and supports two (2) bands simultaneously.
When configured for Vodafone, the Cel-Fi Go X operates on 3G 900Mhz and 4G 1800/2100MHz bands and supports two (2) bands simultaneously.
Cel-Fi Go X Smart Repeater offers a more flexible installation over other Cel-Fi models due to the ability to run cables to where the signal is needed most. By not having a wireless link between two boxes GO can operate in areas that are saturated with Wi-Fi.
- For building and vehicle applications
- Requires external donor and internal coverage antenna
- Locked to Optus or Vodafone Mobile Network
- Carrier approved
- Bluetooth WAVE App for iPhone, Android & Computers
Supported Networks when configured for Optus - Optus, Amaysim, Dodo, iiNet, plus more*.
Supported Networks when configured for Vodafone - Vodafone Australia, Redbull Mobile, plus more*.
*Note: Some supported networks are not fully featured.
- Cel-Fi Go X G32 Smart Repeater - 100dBi
- RFI 7.5dBi Stainless Spring Fibreglass OMNI External Bull Bar Mount Antenna with 5m cable CD7197-B
- Adhesive backed Internal Panel Antenna with 3m cable
- 12V cigarette lighter plug (CLA)
Installation should be carried out strictly in accordance with the Cel-Fi Go X Quick Start Guide and any other information contained in the box. Vehicle installations of the Cel-Fi Go Mobile in particular requires special attention not to interfere with air bag mechanisms, safety and control systems, ABS, stability and traction systems and the vehicles auto electrics in general. You should be familiar with applicable federal and state regulations and industry standards regarding installation. Incorrect installation may result in water leaks, electrical damage, fusing and risk of fire. Misuse of this equipment or failure to follow the instructions in the Quick Start Guide could result in injury and equipment damage. In no event will Comnet Solutions be responsible or liable for either indirect or consequential damage or injury that may result from the installation or use of this equipment. Please contact our Support Team if you have any questions regarding the above precautions. Call (02) 9899 5700 and ask for Smart Repeater support or email email@example.com
Specifications are subject to change without notice. Picture may not be exact model as described.
|2m Antenna Cable LMR195 SMA Male to SMA Female||5m Antenna Cable LMR195 SMA Male to SMA Female||Antenna Mounts||Cel-Fi Go Vehicle Basic Installation|