Telstra Cel-Fi Go Smart Repeater Stationary amplifier module and mains power pack. Requires donor and coverage antenna. See ACCESSORIES below.
Telstra Cel-Fi Go Smart Repeater Stationary model is based on the Nextivity's Cel-Fi GO Mobile Phone Repeater and has been tested, authorised and approved by Telstra for use on the Telstra Mobile Network.
Telstra Cel-Fi Go Smart Repeater is a one box coverage solution for Telstra's Next G® and 4GX networks operating on 3G 850Mhz or 4G 700/1800MHz bands. It is designed to dramatically boost voice quality and increase data speeds for residential and commercial applications.
Telstra Cel-Fi Go Smart Repeater offers a more flexible installation over other Cel-Fi models due to the ability to run cables to where the signal is needed most. By not having a wireless link between two boxes GO can operate in areas that are saturated with Wi-Fi.
- For indoor and outdoor applications
- Up to 900m² indoor coverage area
- Requires external and internal antennas
- Locked to Telstra's Mobile Network
- Carrier approved
- Bluetooth WAVE App for iPhone, Android & Computers
Supported Networks - Telstra, Aldi Mobile, Boost Mobile, Woolworths Mobile and more*
*Note: Some supported networks are not fully featured.
- Telstra Go Smart Repeater Stationary model - 100dBi
- 240V Mains Power Supply
Installation should be carried out strictly in accordance with the Cel-Fi GO Mobile Quick Start Guide and Cel-Fi GO Stationary Quick Start Guide and any other information contained in the box. Vehicle installations of the Cel-Fi Go Mobile in particular requires special attention not to interfere with air bag mechanisms, safety and control systems, ABS, stability and traction systems and the vehicles auto electrics in general. You should be familiar with applicable federal and state regulations and industry standards regarding installation. Incorrect installation may result in water leaks, electrical damage, fusing and risk of fire. Misuse of this equipment or failure to follow the instructions in the Quick Start Guide could result in injury and equipment damage. In no event will Comnet Solutions be responsible or liable for either indirect or consequential damage or injury that may result from the installation or use of this equipment. Please contact our Support Team if you have any questions regarding the above precautions. Call (02) 9899 5700 and ask for Telstra Smart Repeater support or email [email protected]
Specifications are subject to change without notice. Picture may not be exact model as described.
|Donor Antennas||Coverage Antennas||Cel-Fi Battery Backup 12V 24W||Cel-Fi Go G31 CLA 12VDC Car Lighter Adapter|
|Cel-Fi Go Building Repeater Basic Residential Installation||Cel-Fi Go Building Repeater Basic Commercial Installation|